Various matters that should be paid attention to when operating nail making machine

The nail making machine is an industrial equipment used to produce F straight nails, T straight nails and U-shaped nails. With the development of industry, it has been widely used. Here, the manufacturer of KY Pneumatic Nail nail making machine reminds all nail making machine users to follow the safety operating procedures of nail making machine when using nails.

The following are the relevant regulations for the safety operating procedures of nail making machine:

1. Before using the nail making machine, you should turn on the machine to check whether the CNC system display of the nail making machine is normal, whether the feed system is normal, and whether the spindle rotation is normal.

2. Before the machine tool of the nail making machine returns to zero, the X axis should be manually moved about 100mm away from the mechanical origin before the return to zero operation can be performed.

3. In order to make the machine tool of the nail making machine reach a thermal equilibrium state, the machine tool must be idle for more than 15 minutes.

4. Install the alignment fixture and workpiece according to the process requirements (only the workpiece needs to be aligned if there is no fixture), and correctly measure and calculate the workpiece coordinate system.

5. Install and calibrate the tool according to the part processing program, and input the measured tool compensation value into the compensation number of the CNC system, and verify the data.

6. After the operator has a comprehensive understanding of the processing program through trial operation, he can perform trial cutting on the parts.

7. During the trial cutting process, first use single-segment operation, understand one segment, and execute one segment. Before running the program, the magnification switch must be set to a lower gear to check whether the motion trajectory meets the requirements of the drawing. After it is correct, gradually increase the magnification.

8. When the nail making machine is trial cutting, when the tool moves to 30-50mm on the workpiece surface, it must be verified that the remaining coordinate values ​​of the coordinate axis and the coordinate values ​​of each coordinate are consistent with the drawing while maintaining the feed state.

9. After the first piece is processed, it should be self-checked first, and then submitted to QC for first piece inspection.

10. When the entire batch of workpieces is processed, remove the tool from the tool magazine and record the tool length and diameter.

11. After using the nail making machine, stop the coordinate axes of the machine tool in the middle position.

KY Pneumatic Nail reminds you: Follow the safe operation specifications of the nail making machine to avoid unnecessary accidents during the operation of the nail making machine.